On 9/29/2010 7:56 PM, TexasRF@aol.com wrote:
> The decimal value for any fraction is the top number divided by the bottom
> number. 7 divided by 16 is .4375. neither 3/8" or 1/2" tubing will work for
> that.
>
> In over 15 years of selling aluminum tubing, the only user of 7/16" tubing
> I have seen is Hygain, for their element tips. So, you might give them a
> call and get pricing on their 7/16 inch material.
Dealing directly with Hy-gain "in the past" was fast and easy and not at
all expensive. What they are now, I have no idea.
73
Roger (K8RI)
>
> 7/8" tubing is .875 decimal; plenty of that available. The usual wall
> thickness is .058 inches to allow telescoping of adjacent sizes.
>
> 73,
> Gerald K5GW
>
>
>
>
>
>
> In a message dated 9/29/2010 9:45:40 A.M. Central Daylight Time,
> n9wx@hotmail.com writes:
>
>
> Hi Everyone,
> I am missing one part of my TH-7 10M Director...I see that
> DX-engineering/Texas Towers has the tubing parts, but the size is what I am
> not sure of.
> The TH-7 manual says it's 53" of 7/8" tubing for D1 and 43.5" of 7/16" for
> D2, but dx-engineering/TX-twrs uses decimal points not fractions...so,
> anyone know which one would be equivilent and is the manual talking about
> O.D,
> or Wall or what? Probably O.D.
>
> Thanks,
> Daniel N9WX
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|