Towertalk
[Top] [All Lists]

Re: [TowerTalk] Fall Harness-My Choice

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Fall Harness-My Choice
From: "D Calder" <towertalk@n4zkf.com>
Date: Sun, 15 Aug 2010 10:52:51 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I have them, and in 15 years of commercial climbing, I have never been stung
by anything once I'm 10 ft. off the ground. None of my team has that I know
of either.
I don't know what it is about wasps, hornets, and bees, but once you're up
there they leave you alone.

There is also a small company around Atlanta that makes safety climbs also.
Metrosite. Scott will go above and beyond.....

Dave n4zkf


-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Phil Theis
Sent: Saturday, August 14, 2010 4:44 PM
To: towertalk@contesting.com; noid1037@gmail.com
Subject: [TowerTalk] Fall Harness-My Choice

I have 3/8 cable on two of my taller towers.  Wouldn't be without it.
Phil K3TUF



How many folks on here run the 3/8"  winch cable  from top to bottom of the
tower,  and use the positive locking device, hooked to 
your climbing gear of choice?    IE: if you slip, get stung by a wasp, get 
dizzy from the heat, etc., what's  stopping you from falling 100'....aside
from the 
next set of guy wires below you ?   I see the Trylon version of this device
uses a 
shock absorber at the top of the tower.  Some versions use a 3/8"
cable..and some versions use a square tubing rail, running the entire height
of the tower.
Later... Jim   VE7RF

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>