Towertalk
[Top] [All Lists]

[TowerTalk] To guy or not to guy...that is the question

To: towertalk@contesting.com
Subject: [TowerTalk] To guy or not to guy...that is the question
From: Kevin Elliott <kg0mn@yahoo.com>
Date: Thu, 29 Jul 2010 09:40:40 -0700 (PDT)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I am just about to start the installation of my new 40' Rohn 25 tower and here 
is a brief explanation of how it will be setup and what will be on it.  Then 
you 
can tell me whether guying the tower is needed or not.  Due to the small size 
of 
my back yard the guy wires would need to be adjust slightly to stay within the 
confines of my yard.  The tower is going to be attached to a 4' short tower 
section why will be placed into a 4' X 4' X 4" hole with 6 inches of sand and 
rock at the bottom and the short tower section with be set into the rock and 
sand about 6".  The tower is going to be erected beside my detached garage 
which 
measures 20 ft to the center peak.  Approximately two feet from the peak of the 
roof I will be attaching a wall bracket which will be held in place with 
threaded readi-rod to a 4' X 4" pressured treated piece of lumber that will 
span 
five studs inside the garage to spread the load across the entire wall instead 
of depending on two studs.

Now the antenna that will be mounted on the tower which is going to be 
approximately 40' is a Mosley TA-33 and a 5 element 440 antenna and a 6 element 
2 meter antenna.  So with this setup can I get by without the need for guy 
wires?

Thanks
Kevin Elliott - KG0MN



      
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>