On 7/23/2010 7:02 PM, K1TTT wrote:
> No, metal on metal rubbing by itself doesn't cause interference. But if
> there is a voltage difference between the parts that are rubbing THAT can
> cause interference.
>
There I disagree. When the local repeater was here, I could walk up to
the guy lines and rub a 10" screwdriver blade against any of them and
drown out a 50 watt mobile 2 miles away. BUT if they are two metal parts
in the near field they are most likely going to have different voltages
on them.
73
Roger (K8RI)
>
> David Robbins K1TTT
> e-mail: mailto:k1ttt@arrl.net
> web: http://www.k1ttt.net
> AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
>
>
>
>> -----Original Message-----
>> From: Michael Fox - N6MEF [mailto:n6mef@mefox.org]
>> Sent: Friday, July 23, 2010 22:03
>> To: towertalk@contesting.com
>> Subject: [TowerTalk] metal-on-metal interference
>>
>> I've heard that metal-on-metal rubbing contact causes RFI. But doing some
>> Google searches, I can't find a source of information.
>>
>>
>>
>> Can someone tell me:
>>
>> 1) Is this true?
>>
>> 2) If so, is there a source for information?
>>
>> 3) Specifically, is there a general frequency range for the interference?
>>
>>
>>
>> Thanks much,
>>
>> Michael
>>
>> N6MEF
>>
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|