Scotchbrite came back and bit me some years ago. The "metal in it" got in the
pits of elements and actually made the antenna
look like it rusted a month later. Even though it wasn't the aluminum, it was
the metal in the pad. They make brass pads too.
I had to take it down, use 400 grit to get it out and then clear coated it and
it's been up for some time now. It stops it from deteriorating
when you live 900 ft. from the ocean when it's covered with something. I have
some that have been up 7 to 8 years and that's a good
bit next to the sea salt.
73 Dave n4zkf
n4zkf@n4zkf.com
www.n4zkf.com
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of n8de@thepoint.net
Sent: Monday, July 12, 2010 1:08 PM
To: Eric Dobrowansky K2WD
Cc: towertalk@contesting.com
Subject: Re: [TowerTalk] best way to shine up an old yagi?
You can rub it with Scotchbrite pads to remove surface oxidation, especially
where parts join, but WHY would you want it to 'shine'
otherwise?
It will work fine 'dull'.
73
Don
N8DE
Quoting Eric Dobrowansky K2WD <k2wd@comcast.net>:
>
>
> Any recommendations on the best way to shine up a yagi that has been
> lying unassembled under weeds and leaves for a number of years? I
> just picked up a used M2 20m yagi, and want to "shine it up" a
> little before installing it. Any recommendations appreciated.
>
>
>
> Thanks,
>
>
>
> Eric
> K2CB
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|