Works fine for me, though grade 8 nuts would be overkill for most ss bolts.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: Mark K5AM [mailto:k5am@zianet.com]
> Sent: Friday, June 25, 2010 20:11
> To: Larry McDavid; towertalk@contesting.com
> Subject: Re: [TowerTalk] Stainless Steel Galling (Larry McDavid)
>
> At 17:36 2010-06-25, Larry McDavid wrote:
> >If you are screwing a stainless steel
> >bolt into brass or aluminum, don't expect galling. . . .
>
>
>
> Larry, thank you for the interesting comments on galling.
>
> A common situation is a stainless U-bolt on an antenna,
> with stainless nuts supplied.
>
> What would you think about tossing the stainless nuts and
> using Grade 8 plated steel nuts? I would replace the nuts
> each time the U-bolt needed adjustment.
>
> Mark, K5AM
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|