You ran into the same problem I did with the hairpin. You would
think that after 30+ years, that dimension would have been
corrected. The solution is to move the entire element assembly (all
three elements). I will send you the dimensions I used.
I found the electronic versions of the manuals to be slightly
deficient as compared to the printed manuals. I will send you the
dimensions I ended up with including compensation for using a Hy-Gain
balun, the expensive one. Conclusion, it works like a champ on a
small range of frequencies. Optimized for the CW end with the
resonant point being 7.08 MHz, it has a bandwidth from 6.9 MHz to
7.18 MHz where the SWR is less than 3:1. It is an awful lot of work
for 3 S-units but at times I am more than glad I have 'em. Ken K5RG
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|