On Fri, 21 May 2010 17:34:41 -0700, Richard (Rick) Karlquist wrote:
>Get a TWO port network analyzer and connect
>the DUT from the center conductor of port 1
>to the center conductor of port 2. Measure
>S22 and calculate the impedance of the DUT.
EXACTLY! I'm using a similar setup, but with a generator and
voltmeter. Don't get phase, but the magnitude data is good (to within
the limits of stray L and C in my test setup). The dominant factor in
my setup is 0.4 pF in parallel with the unknown.
73,
Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|