Hi all ----
I am in the process of replacing my old HAM-M rotor with a new Yaesu
G-1000DXA and ran into a mounting problem.
The old HAM-M mounted on the DX-48 tower like a glove and worked very well
for years.
What I have discovered is that where my HAM-M mounted just fine, my new
Yaesu G-1000DXA will not.
I have the same issue with the Yaesu GS-065 thrust bearing - the holes don't
even come close to matching.
I am sure I am not the first, nor the last to have this problem, but what is
the solution?
I can picture changing out the rotor and thrust bearing platforms, but with
what?
It would be great if there was some kind of adapter plate that could be
used, but I have not found it yet.
Any suggestions would be VERY much appreciated.
Thanks - Dan
Dan Marler K7REX
6525 Fairfield Ave
Boise, Idaho 83709
Phone: 208-914-8939
E-Mail: K7REX@clearwire.net
http://www.qrz.com/db/K7REX
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|