Thanks for the help, Natan....
I'm confident nothing has been overlooked....
Now if the rain will hold today,
maybe I can get it up in the air!
Thanks again...
73
Neil
AE1P
On 4/24/2010 11:29 PM, Natan Huffman wrote:
> Neil,
>
> I'm glad you saw that! The balun wires go to the 10 meter driver. You'll
> have two wires then connected from the 10 driver to the 20 meter driver.
> The 15 meter driver is part of the open sleeve and thus is parasitically
> connected to the 15 meter cell. Depending on the rev level of the C19XR,
> the closed sleeve (two wires running from the 10 driver to the 20 driver)
> may be either an encased set of two wires or just two wires without the
> outer case. Either works well but the one encased is a bit easier to work
> with.
>
> 73
>
> Natan W6XR
> Freeville, NY
>
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of Neil& Heather
> Sent: Saturday, April 24, 2010 9:11 PM
> To: Tower and HF antenna construction topics.
> Subject: [TowerTalk] Re Force12 C19XR
>
> Quote:
>
> "Verify you are attaching to the longer 20 meter driver and not the 15
> meter driver"
>
> Natan, my manual states to hook the balun to the 10m driver....
> then run the parallel driver wires from the 10mtr driver feedpoints to
> the 20m feedpoints...
> Does it matter???
> thanks...
> 73
> Neil
> AE1P
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|