Ron,
Thanks for the link to article on Brake Delay circuit for Ham II, III or IV
rotators.
To clarify further for those hams not working in teh electronics industry,
you might clarify the following....
The schematic shows the relay contacts N.C. ( Normally Closed )
But the description seems to indicate that the relay contacts are N.O.(
Normally On )
then CLOSE when brake lever is initially depressed
Since many of us have adequate relays in our Junque inventories,
please clarify which state the relay is in when not energized in case we
substitute our own relays
Also, can you tell us what the relay contact Voltage and Current ratings are
?
73, Dennis N6KI
On Wed, Apr 14, 2010 at 8:33 AM, ronald schmid <rollie4x4@sbcglobal.net>wrote:
> They are easy to make if you need to
>
> http://forums.qrz.com/showthread.php?t=241675
>
> RON / N6DCN
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|