Towertalk
[Top] [All Lists]

[TowerTalk] dxengineering U-bolts froze??

To: <towertalk@contesting.com>
Subject: [TowerTalk] dxengineering U-bolts froze??
From: "Bob AD5VJ" <ad5vj@ad5vj.com>
Reply-to: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Date: Tue, 13 Apr 2010 07:37:47 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
I like dxengineering parts; however, I installed my new th6dx this last
weekend with the help of the Azle Ham Club here locally. After taking down
my Hornet Tribander I was disassembling the Hornet from the mounting plate
that I bought from dxengineering.

I bought it with the recommended stainless steel U-bolt clamps they sell
when I put the Hornet up. It was up less than a year on the tower. While I
was loosening a couple of the U-bolt from the mast, the nut holding a couple
of the U-bolts became very hard to take off until I had to place the
assembly in a vice to get enough torque on my wrench to finally get the nut
off along with using a spray lubricant.

The threads are ruined on the nut and the U-bolt since it seemed to cross
thread as it came loose for no apparent reason.

I would have hated to have been trying this on top of the tower hanging from
a strap trying to get it apart.

Has anyone else had a problem like this, I remember it wasn't hard to
tighten when I assembled it as it went on very easily, just taking it off
was very difficult.

73,
Bob AD5VJ


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>