Actually, it didn't bolt on. It just slid over the keyed shaft and
sort of jammed on the shaft. Easy to remove however.
Roy Breon W4ONU
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of KJ6Y@aol.com
Sent: Monday, April 12, 2010 11:46 AM
To: towertalk@contesting.com; Jim.thom@telus.net
Subject: Re: [TowerTalk] Can motorized crank up's be manually
You can do what Steve mentions. Tri-Ex used to supply a handle that
could
be bolted onto the large pulley and although slow, you could lower the
tower and even raise it.
Skip, KJ6Y
_Communications Service Co_ (http://www.communicationsserviceco.com/)
22712 Califa St
Woodland Hills, CA 91367
818-887-3569
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|