Hi all,
I don't know why this is so hard. I'm trying to drill out some hole on
some 3/8" steel plates that I'm going to have galvanized. I bought a 13/32"
drill bit and it worked great for about 10 holes or so. The problem is that I
have about 140 more to go. Any recommendations on a good quality drill bit?
73,
Guy, N7ZG
_________________________________________________________________
Hotmail: Trusted email with Microsoft’s powerful SPAM protection.
http://clk.atdmt.com/GBL/go/210850552/direct/01/
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|