Try Irfanview to look at the DWG file. If you don't have it you can go to
http://www.irfanview.net/ and download a free copy.
Bob W5RN
----- Original Message -----
From: "Dennis Vernacchia" <n6ki73@gmail.com>
To: "towertalk" <towertalk@contesting.com>; "CQ-Contest"
<cq-contest@contesting.com>; <sddxcnews@yahoogroups.com>; "SCCC Reflector"
<sccc@contesting.com>
Sent: Friday, March 19, 2010 1:19 PM
Subject: [TowerTalk] Has Anyone Rebuilt ( New Seals ) a Hub City W300
orsimilar Crank Up Tower Gearbox ?
> Typically used on 70 ft motorized crank up towers like Tri-Ex (
> Tashijian )
> LM-470
>
> Or...if you have not rebuilt one - where did you take to get gearbox
> rebuilt
> for leaky seals ?
> and what was cost ?
>
> I would appreciate if you could forward this info request to anyone you
> know
> might have the answer ?
>
> Pix of it can be seen on Page B6 at *
> http://www.hubcityinc.com/documents/6b-wormgeardrives.pdf *
> First Item "W-Series "
>
> I also have a 58K CAD Drawing file I downloaded from Hub City site but can
> not view with
> my Paint Shop Pro Version 7 software ( W300.DWG file ) - Antone know what
> program
> ( hopefully shareware ) I can view with so I don't have to load Auto CAD !
>
> Got the file here *http://www.hubcityinc.com/wormgear.html* and
> although
> it is supposed to
> be able to be viewed in Paint Shop Pro - I must not have that module
>
> 73, Dennis N6KI
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|