Towertalk
[Top] [All Lists]

Re: [TowerTalk] 2" O.D. Pipe???

To: <richard@karlquist.com>, "Tower and HF antenna construction topics." <towertalk@contesting.com>
Subject: Re: [TowerTalk] 2" O.D. Pipe???
From: "Richard M. Gillingham" <rmoodyg@bellsouth.net>
Reply-to: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Date: Wed, 17 Mar 2010 19:24:17 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
My error.  Tubing is measured OD though, right?

73
Gil, W1RG
----- Original Message ----- 
From: "Rick Karlquist" <richard@karlquist.com>
To: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Sent: Wednesday, March 17, 2010 7:21 PM
Subject: Re: [TowerTalk] 2" O.D. Pipe???


> Richard M. Gillingham wrote:
>> Pipe is measured ID..  TUBING is measured OD.  Try tubing..
>>
>> Good luck.
>> 73
>> Gil, W1RG
> 
> No, pipe is measured by OD, but specified by "trade size".
> 
> Trade size "1 1/2 inch" pipe has an OD of 1.900 inches.
> The ID varies with wall thickness.  Schedule 40 has an
> ID that is slightly larger than 1.5 inches and schedule
> 80 has an ID that is slightly smaller than 1.5 inches.
> The ID can also vary depending on what material the pipe
> is made from.  Thin wall sprinkler pipe has an ID that is
> considerably bigger than 1.5 inches.
> 
> Trade size "2 inch" pipe has an OD of 2.375 inches.
> Again the ID varies above and below 2 inches.
> 
> This is actually good because you know that anything with
> 1.9 or 2.375 OD is almost certainly water pipe, which
> you probably don't want to use for antenna support.
> 
> The reason why the OD of pipe is invariant vs wall thickness
> is so that they only need one threading system for all
> schedules/wall thicknesses, and so that fittings are
> interchangeable between schedule 40 and schedule 80 (also
> other schedules in PVC).  Also, the OD is held to a very
> close tolerance so the fittings fit, whereas the ID has
> very loose tolerances and I have found when buying actual
> pipe that it indeed varies all over the place and is sometimes
> out of tolerance, even though the tolerance is loose.  I have
> probably annoyed a number of pipe salesmen by taking a pair of
> calipers to their pipes to check ID before buying.
> 
> Rick N6RK
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>