Hi Jim, I am getting ready to buy a couple of the polyphaser ones after
researching it a bit.
Joe
KI4TZ
Jim Miller wrote:
> I've seen lots of advice on grounding and protection of antenna signal leads
> but little on what to do with the rotor cable. It seems that since it is
> elevated and remote it is likely subject to similar pickup issues.
>
> Or am I missing something?
>
> I'm assuming I should bring it through the same service entrance location as
> the coax. What to do about protection etc?
>
> 73
>
> jim ab3cv
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|