Towertalk
[Top] [All Lists]

[TowerTalk] Orion/Msq Rotator's

To: Towertalk <towertalk@contesting.com>
Subject: [TowerTalk] Orion/Msq Rotator's
From: jcowens1@comcast.net
Reply-to: "Tower and HF antenna construction topics." <towertalk@contesting.com>
Date: Thu, 4 Mar 2010 19:33:26 +0000 (UTC)
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>

The earlier Orion rotator's had AC motors which is what I have (RC2800P-A). The 
rotator has limit switches at each end of the rotation range which will 
interrupt the drive voltage whether or not you release the control switch. I 
don't think it is possible to "toast" one. Msquare units now have dc motors 
which are an improvement. The ac motors work fine, but are a little more 
vulnearable to noise which can cause it to continue rotating after you release 
the control. I bought mine used about 6 years ago and it does this about twice 
per year. Immediately turning off the power switch will interrupt this 
erroneous operation, and then you can re-check position calibration. Re-setting 
the calibration is very simple. 



I believe I just read another email about someone who had a mast securing bolt 
shear off. Orion/Msquare specifically recommends that you do not secure the 
mast to the rotator clamp with a bolt. High torque produced by a wind gust 
could destroy the rotator drive gears and ruin you rotator. 


John Owens -  N7TK 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>
  • [TowerTalk] Orion/Msq Rotator's, jcowens1 <=