Beware! The colors are not all the same. Trace the circuit
and never trust the colors. The circuit is not that complex
and is relatively easy to trace since you're really looking
at: two wires for the brake (1 & 2), rotate left (6), rotate
right (5), pot (3 & 7) and capacitor (4 & 8).
73,
... Joe, W4TV
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of Van K7VS
> Sent: Sunday, February 28, 2010 10:11 PM
> To: Tower and HF antenna construction topics.
> Subject: [TowerTalk] HAM M SERIES INTERNAL LUG WIRE COLOR PIN OUT
>
>
> FORWARD FROM BRAD W9FX
> PLEASE SEE COMMENT AT BOTTOM
>
> Terminal Wire(s) color
>
> 1 Brown Black Black
> 2 Large yellow wire (from solenoid)
> 3 Green
> 4 Blue
> 5 Orange
> 6 Small yellow
> 7 White
> 8 Red
>
> 73, Brad, W9FX
>
> OVER THE YEARS THE WIRE COVERING COLORS FADE AND ACTUALLY CAN
> CHANGE SO BE
> VERY CAREFUL. YOU MAY BE ABLE TO FOLLOW THE WIRES BACK FROM
> THE SOLDER LUGS
> AND DISCOVER THE ACTUAL WIRE COVER COLORS NEAR THE MOTOR
> MOUNT AS I DID. I
> HAD TO UNSOLDER THE WIRES AT THE LUGS AS I COULD NOT BREAK
> LOOSE THE SCREWS
> HOLDING THE ROTOR CONTROL WIRE SCREW TERMINAL FIXED TO THE
> BASE OF ROTOR.
> VAN, K7VS AND THANK YOU ALL FOR THE HELP.
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|