Yet another project that isn't going to happen.
All-aluminum welded construction.
Fits 18"-face tower, eg, Rohn 45.
Gate swing is around 240 degrees.
One platform/shelf for rotator, one platform/shelf for thrust bearing holding
top of gate. Platforms are 3/16" thick trapezoids, 16-1/2" base-1, 7-1/2"
altitude, 14-1/2" base-2. Support arms are 1" x 2" x 24", 1/8" walls.
Long gate side is 48", 2" od, 1/8" wall. Short gate side is 27", 2" od, 1/8"
wall. Long-short spacing is 27" center-to-center. Long and short sides are
connected by 2" x 2" square tubes.
3" Unarco-Rohn brg included for top support of gate.
I have some pictures. Email me off-reflector: davidjw _at- cinci dot rr dot
com
You supply U-bolts and other hardware.
I ship conus for $350 ono.
Tks for reading.
Brgds,
Dave Windisch, W8FGX
513-674-7202 any time
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|