:::: You were not crimping the lug?
I would crimp it AND solder it.
----- Original Message -----
From: "Ken Eigsti" <diverken@chaffee.net>
To: <towertalk@contesting.com>
Sent: Thursday, January 14, 2010 18:02
Subject: [TowerTalk] broken balun wires
> Here is my problem.
> I have a Force 12 C36XN and I use a Force 12 balun with the 2 wires
> (3.5"each ) that exit one end of the balun and connect to the antenna. (40
> meter portion)
>
> Twice in less than a year, the wire has broken where I have it soldered to
> a
> spade lug that connects to the terminal on the antenna.
> Obviously the vibration is breaking the wire at the solder joint on the
> lug.
>
> What is the best method to prevent this? Crimping the wire on the lug? No
> solder? Luckily I can reach the balun/connections by leaning out from the
> tower.
>
> Any thoughts?
>
> Thanks
> Ken W0LSD
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|