Since the main purpose of a mailing list is to talk to everyone on the
mailing list, the default for most mailing lists is for the "Reply-To"
header to point to the mailing list itself. It thereby takes care of
the majority of the users' replies and keeps discussion on the list
where everyone can benefit. The minority usage is to only reply to the
original sender. Most people do not wish to reply only to one or two
people in the message, but to reply so all can see. The default should
be to convenience the majority of usage, not the minority.
While I've seen a few more lists start to behave as TT, after close to
20 years involvement in email lists, I have to say it is not the norm
and is disconcerting and annoying to most people, as it is not how they
expect a list to behave.
--JohnK
73 de W5NNH
10X 75371/M&M 117/SMIRK 6185/Six Club 285/TRA 2499/Norcross 228 F&AM
W2RU - Bud Hippisley wrote:
> On Jan 11, 2010, at 12:30 PM, Marlon K. Schafer wrote:
>
>
>> On a personal note, this is the ONLY mailing list that I'm on that does NOT
>> reply to the list! It drives me nuts. I have to remember to hit reply-all
>> then take out the individual's email address etc.
>>
>
> Duh....I thought that was the purpose of "Reply All".
>
> -1 here. Please don't change the way the "Reply" function works; I much
> prefer to "have" to hit "Reply All" than to rue sending a private reply back
> to everyone. Also, Marlon....please tell me what _single_ key I can hit to
> send a reply back to only the original poster if "Reply" sends it to the list.
>
> Bud, W2RU
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|