I have the two-element version of the same Force 12, 40 meter antenna.
I tuned mine in conjunction with the original instructions which provided
for its best performance...both SWR and F/B. My lowest SWR is found at
7.050 and am able to work between 7.0 mhz to about 7.1 mhz without a tuner.
Beyond 7.1, such as when working split DX SSB, I use my Palstar tuner.
I still have directivity in the SSB portion of the band, but not as much as
when I am the lower portion of the band.
Conclusion: I agree with Rick. While you do eliminate the need for a tuner
by using the Jennings cap, to retain full F/B performance, you need to
adjust the dimensions of all three elements.
Jim
KBØX
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Richard (Rick)
Karlquist
Sent: Tuesday, December 29, 2009 9:47 AM
To: Jim Thomson
Cc: towertalk@contesting.com
Subject: Re: [TowerTalk] Motor Driven vac used in 40M DE?
Jim Thomson wrote:
> Has anyone tried this b4 ? I have a F-12 340N, used, of recent vintage.
> OK... here's the deal. I'm seriously thinking of installing a
Jennings ceramic 10-1050 pf @ 15 kv motor driven vac cap in series with
the hot leg of the DE.
>
> On paper, after doing the math's... this should work... and result in a
flat swr across the entire band. The stock swr curve is ok.... but I
want to be able to operate at the opposite ends of the band. F-12
measures the swr curve in the shack, using the FT-1000MP's internal SWR
meter.... and 400' of LMR-400 to the yagi. The real swr curve,
measured at the DE, is of course, higher. [worse]
>
> Have any of you tried this b4.. or seen it done ? The idea was to tune
the DE to the bottom of the band... or even a little lower. Then with
1050 pf dialed in.. [ 21.7 ohms Xc]..... swr should be flat at 7003 khz.
As I move up the band, less pf required. .. [ more XC]
>
I did some antenna range tests with my MonstIR, varying the driven
element length while leaving the director and reflector fixed.
You can improve the SWR bandwidth doing this, but the gain and
F/B drop off as you get away from the optimum frequency
to which the parasitic elements are tuned. You really need to
tune all 3 elements as is done in the MonstIR.
Rick N6RK
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|