There is one big advantage of the return loss test, besides measuring double
the loss (down and back) which gives a more sensitive test... and that is
you don't have to go to the far end of the cable. I can test most of my
main cables here from the shack by just opening the remote switch and
putting a bit of power down the line... makes for a quick and easy test with
built in instrumentation, just flip a switch and its basically done.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: gdaught6@stanford.edu [mailto:gdaught6@stanford.edu]
> Sent: Thursday, December 10, 2009 21:03
> To: towertalk@contesting.com
> Subject: Re: [TowerTalk] Resistance of RG-8 cable?
>
> K1TTT wrote...
>
> > I think a better test is a return loss test at 10m, leave the
> > far end either open or shorted and measure the reflected power or swr,
> the
> > higher it is the better the cable.
>
> Or, put a good dummy load at the far end, and measure the RF power out of
> the
> exciter into the cable. Now, without changing RF level, move the power
> meter down
> to the dummy load end and measure the power being delivered to the dummy
> load.
> Now you've measured the actual loss in the cable. Compare it with the
> manufacturer's specified value, and you know if it has degraded. If the
> resulting loss
> is something you want to live with, keep using the cable!
>
> Remember, the loss of brand-new, high-quality cable IS NOT zero!
>
> 73,
>
>
>
> George T Daughters, K6GT
> CU in the California QSO Party (CQP)
> October 2-3, 2010
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|