OM Tom,
Lots of good advice regarding the use of Scitchbrite and an aluminum-bearing
joint compound.
I've just now finished getting my trap rotary dipole (modified from the
reflector section of a TH-3) back together and would like to add a bit to the
discussion.
Assuming you have a new antenna, wipe the joints down with 91% isopropyl
(rubbing) alcohol before using the Penetrox.
If your antenna uses "hose clamps" to cinch the sections together, toss into
the trash the ones that came with it unless you can verify they are all
stainless. The worm gear screw and housing are frequently made of ordinary,
plated steel. Replace with "All Stainless (a trade name) or Breeze (another
trade name.) Both are US companies who make
their hose clamps from 100% stainless. Prepare to pay a multiple of what a
cheapie clamp costs but you will be spared much frustration when you have to
service the antenna. (I learned this the hard way...HI!) You may have to go to
a smaller hardware store to get these or a place that cares about doing a good
job repairing automobiles. Perhaps some of the good folk on the list can
recommend a mail-order house. I've the good fortune of having an old-time
hardware store within walking distance which carries the good stuff.
After you get the antenna together, wipe the whole thing down with 91%
isopropyl alcohol and give the antenna (except the coax connector) a coat of
liquid automobile wax. I've found this technique keeps the antenna shiny for
several years.
I prefer to use a synthetic grease to "flood" the coax connection. If you use
the rubber tape sealing method, the synthetic grease will not attack the rubber
tape as the carrier in joint compound might. This material is available at
Radio Schlock and is just fine.....used it in
my antenna business for many years. I've had bad luck with "Coax-Seal"
as it tends to harden after several years.
You may wish to swap out the mast-to-boom bolts if they are not stainless
steel. In any event, use some anti-seize compound (not the same as the joint
compound) on the bolts to make servicing easier. You can get a small amount of
anti-seize compound at your auto supply store. It comes in essentially 3
"flavors" Nickel-bearing, Copper-bearing and Zinc-bearing. Any of these will
do fine. I tend towards copper-bearing.
Hope to see you in the ARRL 10 meter contest this weekend.
72,
Tim
____________________________________________________________
Nutrition
Improve your career health. Click now to study nutrition!
http://thirdpartyoffers.juno.com/TGL2131/c?cp=mZa9k_xP6xwq8kAGouE2ZwAAJz1QobnAx2zzdKUb2JrD3w3cAAYAAAAAAAAAAAAAAAAAAADNAAAAAAAAAAAAAAAAAAASQwAAAAA=
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|