I would use a 1/4" shackle (which has a 5/16" pin) to attach what ever you were
going to use to get the tower upright. A 1/4" shackle has a working load of
1000 lbs, which should be more than enough since you are not dead lifting the
tower.
see this link:
http://turnerseymour.thomasnet.com/viewitems/hardware/screw-pin-anchor-shackles?&plpver=1001&forward=1
Clint - W5CPT
----- Original Message -----
From: Art
To: towertalk@contesting.com
Sent: 03 December, 2009 7:58 PM
Subject: [TowerTalk] Old HWS671
I'm about to pull a HWS671 vertical. There's a pad welded on the outer
section. For those with an erection fixture it was used to install a
pulley wheel to winch up the tower. I don't have a fixture, but I do
have a tractor that I intend to pull it up with. The plan is to use 1/4
inch 7x19, same stuff the tower uses, on a thimble around a bolt through
the pad ordinarily used for a pulley with the erection fixture.
The question is, what grade of bolt do I buy that will pull it up and
not break? I see it as a fight between ductility and brittleness, grade
8 being brittle for shear loads like this. The hole is for a 5/16 --
which seems a bit small to yank up this tower. I'm sure it used to work
when these towers were new 30-40 years ago. The alternatives are, drill
out the hole for a bigger bolt or use a chain, either one putting the
galvanizing at risk.
HWS671 is a 4 section 71 ft middling strong crankup weighing about 1400 lb.
73 Art
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|