They connect to the coax shield at the feedpoint of the vertical, but should
be insulated at the far end. The far ends are at high voltage (assuming
they are about 1/4 wave long) so would arc to a wood support and make noise
or burn the wood.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: Pat Chiles [mailto:chilesp@comcast.net]
> Sent: Saturday, November 28, 2009 15:09
> To: towertalk@contesting.com
> Subject: [TowerTalk] Raised Radial Question
>
> I am installing some raised radials on full size 80M verticals. I have
> never done raised radials before. My questions are a. do you insulate
> them for the vertical support mast (wood)? and b. are they connected to
> ground?
>
> Thanks,
>
> Pat, K8PC
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|