Thanks, Gerald.
Mike NF4L
TexasRF@aol.com wrote:
> This is normal for the smallest size, HPTG1200I. All other sizes are
> intended to be terminated with Preformed Products guy grips designed
> special for Phillystran.
>
> 73,
> Gerald Williamson K5GW
> General Manager, Texas Towers
>
> In a message dated 10/29/2009 7:58:05 P.M. Central Daylight Time,
> nf4l@nf4l.com writes:
>
> My 4L SteppIR uses small diameter Phillystran as a bridle for the
> boom,
> clamped with saddle clamps. I have the antenna on the ground, and was
> going to replace the saddle clamps with stainless steel ones.
>
> When I took off the old clamps, the 'stran is crushed absolutely flat
> where the U-bolt side bore on it. It appears as tho there is
> nothing in
> the jacket. The jacket isn't broken, only flat.
>
> Is the Philly cut or broken, or is that much crush normal? It doesn't
> seem like a good idea to breach the jacket to have a look-see.
>
> 73, Mike NF4L
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|