Seems like there is some factor for round tubing instead of square -
like 2/3 or something?
Stan, K5GO
----- Original Message -----
From: "Brian Gieryk" <ke6iyc@mac.com>
To: <towertalk@contesting.com>
Sent: Monday, September 14, 2009 10:30 AM
Subject: Re: [TowerTalk] Wind Surface Area
> length (in inches) times OD of pipe (in inches) divided by 144 (square
> inches in a square foot) = square feet of wind load
>
> 3 1/3 sq. ft. for the 20' of 2" OD
>
> Brian
> KE6IYC
>
> On Sep 14, 2009, at 8:24 AM, k2qmf@juno.com wrote:
>
>> Hello All,
>>
>> Can some one please tell me what the
>> wind surface area of a 20 foot long
>> 2 inch OD pipe would be ????
>>
>> Many Thanks in advance for the info...
>>
>> 73,
>> Ted K2QMF
>> ____________________________________________________________
>> Best Weight Loss Program - Click Here!
>> http://thirdpartyoffers.juno.com/TGL2141/fc/BLSrjpTFoYbhjR0LLDfA8Oa4Dj4IFEk5FiTpOcaLbyjQonz4ajVOk7tvIQI/
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|