It should not be a problem. Two wires are the motor, three others are
the pot. Those are the only ones that need to be connected for the
rotator to run properly. It is easy to identify them on the rotator,
less so on the control box. Do you have ANY wiring diagrams?
73, Pete N4ZR
New Articles Daily - the Contesting Compendium at http://wiki.contesting.com
The World Contest Station Database, updated daily at www.conteststations.com
The Reverse Beacon Network at http://reversebeacon.net
On 9/4/2009 12:05 PM, mikestephens-milkeycorp@comcast.net wrote:
> Can I use a Yaesu G-800SDX Control Box ( 12 -22VDC ) to run the newer
> G-1000DXA Rotator ( 11 - 24VDC ) ? If so would also appreciate wiring cross
> reference. tnx& 73, Mike N7KR
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|