Yesterday I was working on a grounding bar for my feedlines, involving a
piece of plated angle stock with pre-made holes. Silly me, I figured
that I could use a Unibit to enlarge the holes to fit barrel connectors,
particularly if I added a little cutting oil for cooling and went slow.
Silly me, my $35 Unibit now has at least two steps that are dead. I
figure there are some pretty smart fabricators on here, and hope someone
can advise on whether or how a Unibit can be resharpened.
--
73, Pete N4ZR
New Articles Daily - the Contesting Compendium at http://wiki.contesting.com
The World Contest Station Database, updated daily at www.conteststations.com
The Reverse Beacon Network at http://reversebeacon.net
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|