Towertalk
[Top] [All Lists]

Re: [TowerTalk] Philly installation

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Philly installation
From: "Jim Chaggaris" <jimc@pwrone.com>
Reply-to: jimc@pwrone.com
Date: Mon, 31 Aug 2009 22:06:13 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Okay, I'll bite.  What if I am intending to install a AB-577 mast sans the
included guys and I want to use 4000i Phyllistran for the top 2 sets of
guys.  Is this over kill?

73,

Jim N9WW

James Chaggaris
President
PowerOne Corp./PowerOne Environmental
1020 Cedar Avenue
Suite 203
St. Charles, IL 60174
Phn: (630) 443-6500
Fax: (630) 443-6505
Website: www.pwrone.com

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of jimlux
Sent: Monday, August 31, 2009 9:54 PM
To: K7LXC@aol.com
Cc: Cqtestk4xs@aol.com; towertalk@contesting.com
Subject: Re: [TowerTalk] Philly installation

K7LXC@aol.com wrote:
>  
> In a message dated 8/31/2009 6:00:48 P.M. Pacific Daylight Time,  
> towertalk-request@contesting.com writes:
> 
>>  Nothing  says you have to tension the cable to a  particular fraction of

> it's  breaking strength. It's more a matter of  the desired tension for  
> appropriate stability for the  structure.  You could tension million  
> pound breaking strength  cable to the same few hundred pounds as the the  
> regular non-EHS  cable.
>  
>     Are you saying that there is no particular  tension specification for
a 
> guy cable? Please clarify. Since you're an  experienced tower owner, I'd
be 
> shocked if your tower guys were tensioned at  some random tension. 


Not at all.. just that the tension spec is derived from the expected 
loads, not the breaking strength of what you're tensioning.  Obviously, 
there's not much to be gained by using a very low strength member 
(because you want the static tension to be a small fraction of the 
dynamic loads..)

But, if you have a given tower, with given loads, the expected loads on 
the guys would be independent of what the guys happen to be made of or 
how strong they are.

There are some second order effects because stronger materials tend to 
have higher stiffness, but I suspect that's not a big deal.


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>