Here in Southern CA, they charge by the pound with a #200 minimum. I
don't remember how much per pound but am getting ready to have a 3
section tubular tower and free standing rotor base re-galvanized.
As far as clean goes, they will etch it before going in the tank. If it
is real rusty, have it sand blasted.
Dino - KX6D
-------- Original Message --------
Subject: [TowerTalk] Hot Dip Galvanizing
From: "Robert West" <robert.west@just-micro.com>
Date: Sat, July 25, 2009 7:05 am
To: <towertalk@contesting.com>
I'm cleaning up an old 65' freestanding tower and would like to get the
thing galvanized. I live in central Ohio and have looked up a few
places
that advertise the service but haven't called any of them yet. What
price
range should I be looking at and how clean does this have to be before
they
can process it? Anyone have one to recommend in Ohio that they have
used?
I was putting off calling until I had some sort of idea of what was a
good
price and what was a rip-off.
Thanks!
Bob-
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|