Towertalk
[Top] [All Lists]

Re: [TowerTalk] Mast size

To: Jim Brown <jim@audiosystemsgroup.com>, towertalk reflector <towertalk@contesting.com>
Subject: Re: [TowerTalk] Mast size
From: Mike <nf4l_NO_SPAM@nf4l.com>
Reply-to: nf4l@nf4l.com
Date: Fri, 17 Jul 2009 10:50:18 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Thanks Jim -
If it was 25AG2 I'd be home free. :-)       But I don't think it is, 
therefore the pic for ID. 

73, Mike NF4L

Jim Brown wrote:
> On Thu, 16 Jul 2009 19:11:05 -0400, Mike wrote:
>
> I just went through that with a used 25AG2. Measured it with a micrometer, 
> it was something like 2.07 inches i.d. Bought the heaviest 2-inch mast from 
> Texas Towers. It fits very nicely. The mast is something like 2.02 or so.  
>
> BTW -- in line with the discussion about "getting it home" -- I had Texas 
> Towers cut their 10 ft mast down to 9 ft so that UPS would ship it. No 
> charge for cutting, but I bought a 10 ft mast. I figure it's a nice match 
> for a Yaesu G1000 rotator and my 3-el SteppIR. 
>
> 73,
>
> Jim K9YC
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>   

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>