Dan Zimmerman N3OX wrote:
>> Is there a way to build an external box with something like opto-isolators
>>
> to better isolate the driver chips from getting nailed so easily?
>
>
> Well, you need to build something that can source as much current as the
> driver chips.
>
> Wonder what happens if you replace each output with a thousand-volt MOSFET ?
>
Circuits made to take big transients would do something very much like
that.. They use a fairly decent FET or IGBT with 100V or more. Then a
fast clamp on the output (like a back to back thyristor/DIAC) to limit
the voltage (zeners might work, but because their voltage stays high,
they dissipate more power).. Finally, a series transient suppressor (a
LC circuit of some sort) to limit the di/dt, and then a vacuum gap
across the whole thing where it goes to the outside world.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|