Thanks for reading this. I have an old Triex H-354 tower that consists of
three 20 foot steel welded sections that extend up to 54 feet via a manual
cable crank winch. This tower was made by Triex Tower in Visalia, California
many years ago (Serial number 54003). The tower is different from the LM 354
in that instead of having a "W" pattern on the sides it uses flat bar welded to
the tubing that lies horizontally when the tower is standing up. The tower
probably weighs in the 350 to 450 pound range. There is a single bolt lug at
each of the three corners, and is obviously designed to be cranked over. Can
anyone tell me 1, Is The Tower OK for freestanding configuration? 2, What is
the acceptable wind loading on this tower? Any advice would be appreciated,
thanks in advance from James N3ZS.
James.archer@erm.com
________________________________
This message contains information which may be confidential, proprietary,
privileged, or otherwise protected by law from disclosure or use by a third
party. If you have received this message in error, please contact us
immediately and take the steps necessary to delete the message completely from
your computer system. Thank you.
Please visit ERM's web site: http://www.erm.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|