N3XX wrote:
> You might try DX Engineering.
> http://www.dxengineering.com/sections.asp?DeptID=39&ID=1
>
>
Their prices may be a bit higher, but the quality is good and you will
get what you need in the way of SS U-bolts and Saddle clamps.
I've gone to using saddle clamps for all antenna mounting to cross booms
and mast clamps.
They have a good on-line system, but if you aren't sure about what you
need they've always been helpful on the phone.
73
Roger (KI8RI)
> 73,
> Tim - N3XX
>
> ----- Original Message -----
> From: "AD5VJ Bob" <rtnmi@sbcglobal.net>
> To: <towertalk@contesting.com>
> Sent: Monday, May 18, 2009 4:59 PM
> Subject: [TowerTalk] U Bolts
>
>
>
>> I am looking to purchase some hardware including, U Bolts for attaching my
>> antenna to the MAST on the Tower and dont know anything
>> about Metals or building materials.
>>
>> Texas Towers doesn't seem to have them on their site.
>>
>> I want a U Bolt that will handle a 2" MAST, but what other specifications
>> do I look for and where do I buy one that is high quality
>> not some import that is going to fail after a couple of months.
>>
>> Bob AD5GJ
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|