The rotator will set in a cage approximately 20 feet from the thrust bearing
until it drives a 20 ft section of 2" Chrome Molly Mast that will hold
approximately 30 Sq. ft of antenna's. SC coastal location and could always
the chance it could see 100+ winds. The basic concept is like a driveshaft
in a car. Also the design is so we can change out the rotator without moving
the shaft ass. other than a inch upward to allow the rotor to slide out.
It's a big project and hope to get into service by summer's end. TX Gene
K2QWD
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|