All:
I have a 6M beam that is showing high SWR (10:1). I checked each connector
to the antenna by disconnecting and placing a dummy load. Finally up at the
antenna, I disconnected the antenna, and placed the dummy load as the
antenna. Readings were 1:1 SWR. I then clean up the connector at the
antenna, and retest. SWR is still high.
I then pull down the antenna (K1FO or similar - not M2) and check it out.
With the coax disconnected, I check the connector - good continuity from the
center pin to the otherside of the connector (where the gamma match is
attached.
I check from center pin to ground on the conductor to see if shorted -
Circuit is open.
I check to make sure I have continuity between outside of gamma and rest of
antenna. Circuit is fine - and shows continuity.
The only thing I can think of left is to replace the coax less shield inside
the gamma.
What else can it be?
I was hoping to get this up higher in the air for the summer Es season.
Thanks
Scott
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|