Towertalk
[Top] [All Lists]

Re: [TowerTalk] JB Weld

To: towertalk@contesting.com
Subject: Re: [TowerTalk] JB Weld
From: Bill Powell <whp@att.net>
Reply-to: whp@att.net
Date: Sat, 11 Apr 2009 22:15:48 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
A quick and dirty test for JB Weld as an RF insulator:

Mix up a small lump, let it harden and microwave it (along w/ a cup of water).
If it get's hot it has absorbed microwave energy and is a questionable RF 
insulator.

Bill - WB1GOT

>   8. Re: JB Weld (Mike)
>-----Original Message-----
>From: towertalk-bounces@contesting.com
>[mailto:towertalk-bounces@contesting.com] On Behalf Of Dennis W0JX
>
>JB Weld is a wonderful adhesive. It has better tensile strength than most
>epoxies (listed as 3960 psi on the package). It will adhere to plastics in
>situations where most other epoxies will not. It will adhere to aluminum
>tenaciously if the surface is cleaned and roughed up a bit.
>?
>However I question its insulation qualities at RF. While the packaging says
>that it "does not conduct electricity" the packaging also states "The unique
>J-B Weld formula of liquid steel and compound hardener..."
>?
>Therefore, I would avoid using it where a radiating or parasitic element
>touches the compound itself. However, you could put some kind of appropriate
>insulating barrier between the J-B Weld compound and the radiating/parasitic
>element.
>?
>Dennis W0JX/8
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>