Tom -
I've always pinned my masts to the rotators, including a G-1000DXA and
G-2800DXA. I've had no problems with the moderate size antennas I use, e.g.
4-el SteppIR, Magnum 240N 2-el 40.
My reasoning was that I didn't want to risk slippage and then have to go up
and realign the antenna. If the rotator broke because it was pinned to the
mast, I felt that just meant I needed a bigger rotator.
The only interesting thing I can add to this discussion is the fact that
bolts used to pin antennas to masts do shear. I thought the force required
to shear even a low grade bolt would be enough to destroy any rotator.
Apparently not so, as I've heard many stories about even high grade bolts
shearing before the rotator failed.
73, Bob - W3YY
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of mrlogs
Sent: Thursday, March 12, 2009 12:19 AM
To: towertalk@contesting.com
Subject: [TowerTalk] Pinning my mast in rotator clamp
Hi All..
My Yaesu G-1000DXA manual say's to drill thru the mast & put a bolt thru
the rotator & mast to keep it (the mast) from turning in the clamp. I was
told to do a survey here & get everyone's input on doing this as it might be
a bad idea..
Thanks for your input!
73'..Tom N3ZC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|