Craig,
Just use an el-cheapo hobbyist saw bench fitted with a fine toothed
carbide tipped blade.
For lubrication, use a cake of soap. Just a quick wipe on the blade
before cutting the aluminium.
WATCH YOUR FINGERS ARE NOT TOO CLOSE TO THE BLADE !!!
Ensure you use eye protection as well, as you produce small, HOT
chips of aluminium.
I have used this method in industry for many years.
Gary
VK4ZGB
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|