Tony, I know this has been said before but be sure you get 2" tubing not 2"
pipe. Tubing is measured in outside diameter and pipe is in inside
diameter. Also, be sure it is 6061-T6 alloy. Some other grades of aluminum
are designed to be bent and are soft alloy. I'm posting this in hopes it
will save you time, labor and money.
Dave
----- Original Message -----
From: "k2vi" <k2vi@cox.net>
To: <TowerTalk@contesting.com>
Sent: Saturday, February 28, 2009 3:25 PM
Subject: [TowerTalk] mast material
> The ignoramous calling people dumb ass as well as using an anomyous to not
> be indentified, You exhibit the intelligence of a mole with no
> class.Obviously your parents treated you poorly and now your mad at the
> world and lashing out with verbal attacks.You probably need counciling.
> Get it!...I want to thank everyone for the input in regard to the mast
> material. After gathering all your helpful input I decided to use 2"
> aluminum 1/4" wall thickness to hold a 42" mosley classic -33 and put it
> 6' above the thrust bearing.Reason is the galvinized pipe weighs a ton and
> was very difficult to get it slipped thru the thrust bearing.73s to all
> and thanks again.
>
> tony k2vi
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|