yeilg@aol.com wrote:
> Hi,? I am looking for the best, preferably one step, strippers .... one tool
> that will
Doesn't exist that I know of...Besides if it's adjustable for all sizes
it's likely to be out of adjustment for the one you want.
I used to old, "Box Cutter" method for years along with solder
connectors. Then I tried a number of strippers. I now use all crimp
connectors. For strippers I use a two step Tessco ST-600EZ for LMR-600
(bit pricey), a three blade and two blade (don't remember the make or
model numbers) for N and UHF connectors on RG8/LMR-400 sizes, and a
third for RG6/RG8X & RG58. They are pretty much "grab and use". I
purchased mine from Davis RF and no, I have no connection with the
company. Oh! I also have to crimping tools, one for the LMR-600 and one
for the "other stuff" with two sets of dies.
73 and good luck,
Roger (K8RI)
> do small coax (RG-58 etc)???AND ?large (Bury-Flex, LMR-400, etc.)?AND for
> both UHF and N connectors. ? I have heard that there is one out there that
> does all of these vs. having to have 2 or more tools.? Any help
> appreciated.???Thanks !,?George,?soon to become a K7??
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|