Pete,
Thanks for response, I would be interested to know what a new LM-470 looks
like and whether it does have notched cut out by the factory.
Thanks,
Mike, K6BR
-----Original Message-----
From: Pete M [mailto:pmanfre@gmail.com]
Mine (2) all have done that...I think the notch was put in at the
factory....hasn't hurt anything....but I did have to change the cables after
30 years.
Pete WA2ODO
----- Original Message -----
From: "Mike, K6BR" <noddy1211@sbcglobal.net>
To: <TOWERTALK@contesting.com>
Sent: Sunday, January 11, 2009 3:59 PM
Subject: [TowerTalk] Tri-ex LM-47 Cables
> All,
>
>
>
> I have a used LM-470 tower and on close inspection I can see that the
> raising cable has cut into the V Braces at the bottom where the cable
> comes
> from the pulley and also at the top where it leaves the pulley.
>
>
>
> The cable goes on the inside of the first V Brace and then on the inside
> of
> the rest of the braces, is this normal as the cable has worn almost an
> 1/8"
> in the V Brace at some places?
>
>
>
> Thanks for any help.
>
>
>
> 73, de Mike K6BR
>
>
>
> <http://www.k6br.net/> http://www.k6br.net
>
>
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.10.5/1886 - Release Date: 1/10/2009
6:01 PM
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|