Towertalk
[Top] [All Lists]

[TowerTalk] Fwd: BCB Intermodulation

To: towertalk@contesting.com
Subject: [TowerTalk] Fwd: BCB Intermodulation
From: hanslg@aol.com
Date: Thu, 08 Jan 2009 22:47:16 -0500
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
It appears as you have a case of intermodulation?generated in?a semiconducting 
junction somewhere. You obviously have a couple of strong AM stations close by. 
Did?this started recently or have you had this for a long (or all)?time?

This phenomena can happened in many different ways, bad connection or corrosion 
in a connector, corrosion in a junction between two metal objects such as the 
sheet metal in a metal roof, connection between two pipes in an antenna mast 
etc. The possibilities are endless.

The offending junction is probably relatively close by indicated by the 
strength of the interference. You should look for what I tried to describe 
within a few hundred feet from your antennas. Hopefully you will be able to 
find something that can be easily fixed.

Good Luck and 73 de N2JFS, Hans


-----Original Message-----
From: Ed Richardson <ed_richardson@shaw.ca>
To: 'Tower' <towertalk@contesting.com>
Sent: Thu, 8 Jan 2009 10:02 pm
Subject: [TowerTalk] BCB Intermodulation



Just wondering if anyone has experienced intermodulation caused by some
component in an antenna system? I am getting severe broadcast band
intermodulation across the 80m band and have ruled out the receiver.

The intermodulation takes the form of (2x Frequency 1) + frequency 2. I
have no less than 6 strong AM stations that all interact with each other
to basically wipe out most of 80m. The intermod products vary from S9 to
S9+20dB.

I have installed a high pass filter in line that reduced the
fundamentals at least 40 dB but the intermod remained unchanged. Added a
30 dB pad on the input, no change in intermod except being reduced by 30
dB.

I have a single feedline (7/8" Heliax) with a jumper to the radio
connected to a RATPAK tower mounted switch. Switching between multiple
antennas yields intermod with slightly varying levels. When selecting an
open connector port, Intermod drops to almost nil but is just slightly
detectable.

Any suggestions where to look next?

Ed
VE4EAR  

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>