Towertalk
[Top] [All Lists]

Re: [TowerTalk] Was "43ft Vertical Feeding Question and Balun Type"

To: "Richard Thorne" <rmthorne@suddenlink.net>
Subject: Re: [TowerTalk] Was "43ft Vertical Feeding Question and Balun Type"
From: "Greg" <ab7r@cablespeed.com>
Date: Sun, 23 Nov 2008 16:57:44 -0800
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Wouldn't  the relay in a meter like the LP-00 or Powermaster work for this 
by cutting the keying line to the amp when the SWR is too high?

Greg
AB7R

----- Original Message ----- 
From: "Richard Thorne" <rmthorne@suddenlink.net>
Cc: <towertalk@contesting.com>
Sent: Sunday, November 23, 2008 4:48 PM
Subject: Re: [TowerTalk] Was "43ft Vertical Feeding Question and Balun Type"


> With the CG tuner you would have to take the amp off line manually, then
> key your rig so a tune cycle would take place.  I'm sure the tuner
> instructions state to do this at low power 10-20 watts.  Most modern
> rigs reduce the power when they see a high swr, so you normally wouldn't
> have to reduce the power manually.
>
> Once the tuner is tuned you could hit the amp operate/standby switch and
> start running with high power.
>
> I would probably forget to turn the amp off in the heat of the moment, I
> would rather the tuner interrupt the ptt line so tuning is totally
> automatic.
>
> Rich - N5ZC
>
> Richards wrote:
>> I am a rookie at all this... so please be patient.   I thought the
>> instructions
>> to the tuner said you have to reduce power to the antenna-tuner and
>> tune with like only 5-10 watts of power, and then put the power back
>> up.   I guess you are saying you would have to take the amp off line
>> or tune it way low, and then tune the antenna... and then either put the
>> amp back on line, or re-tune the amp up to power each time you
>> re-tuned the antenna.
>>
>> Is there something I am missing here?
>>
>> ==============  Richards - K8JHR  ===================
>>
>> Richard Thorne wrote:
>>> The only problem I can see with this tuner is not having the ability
>>> to break the PTT line between the rig and amplifier (confirmed by
>>> Array Solutions).
>>>
>>> A high power tuner should operate like the SGC-500 or the 1500 wat
>>> MFJ auto tuner.  When a tuning cycle begins it should interrupt the
>>> ptt line to the amp so it can tune under low power, then when the
>>> tuning cycle is complete, allow the ptt line to key the amp.
>>>
>>
>> ==================================================
>> ------------------------------------------------------------------------
>>
>>
>> No virus found in this incoming message.
>> Checked by AVG - http://www.avg.com
>> Version: 8.0.175 / Virus Database: 270.9.9/1807 - Release Date: 
>> 11/23/2008 10:59 AM
>>
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.175 / Virus Database: 270.9.9/1807 - Release Date: 11/23/2008 
10:59 AM

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>