to the Towertalk reflector...
I have a Georgia Copper bar for a single point ground behind my gear
using flexweave between each unit and the bar.
the bulkhead is the MFJ wooden board product with a short piece of
metal plate on both indoor/outdoor sides connected with barrel
connectors, etc. those ground both sides to each other.
I have drilled a couple of holes away from the plate to pull my 240V
thru the bulkhead from an outside service panel to provide juice for
the amps. The 120VAC also comes thru the bulkhead from that same
service panel to supply the radios, etc. grounds for the service
outlets go to the ground bar also. mixing DC and RF grounds. hmmmm
question. how do I connect that inside ground bar thru the bulkhead
to the ring of 8' ground rods outside my window???
I plan to use 1.5" wide copper strap from the bulkhead-outside to the
ground rods and to tie the ground rods together. but I cannot figure
out how to get from the copper single point ground bar THRU the
bulkhead to that outside copper grounding strap.
do I drill a hole thru the wood and coil up some strap and push that
thru the hole? do not know how to physically connect the two sides
both mechanically and electrically.
The bulkhead DOES have a screw with insulators which goes thru the
bulkhead much like the two screws for the ladder line. but it is for
a single long line. could I use that?
help???
thanks
chas k5dam
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|