This one is labeled as "Falnir LCJ 1-15/16" New Britain, Conn."
I need to locate a ring to clamp the mast to the thrust bearing. The
original is missing.
Any ideas on where to find one?
As far as re-greasing it. I figured it out. While taking a closer
inspection I found it has screw tap in it for a grease fitting. I'm not
going to need to pull it.
Drax
KB3X
From: Wayne Kline [mailto:w3ea@hotmail.com]
Sent: Thursday, October 30, 2008 11:21 PM
To: draxfelton@gmail.com; towertalk@contesting.com
Subject: RE: [TowerTalk] Thrust bearing re-grease
Drax...
I need you to be more specific ,, Is it a Rohn ? ( Rohn thrust bearing have
ROHN cast on the flange and TB2 or TB3 and three 3/8 locking bolts )
Wayne W3EA
> Date: Thu, 30 Oct 2008 23:10:18 -0400
> From: draxfelton@gmail.com
> To: towertalk@contesting.com
> Subject: [TowerTalk] Thrust bearing re-grease
>
> Could someone recommend what puller tool I would need to beg, borrow,
> or buy to pull a thrust bearing apart with to re-pack it with grease?
> I'm not that familiar with bearings or whether the tool used for
> automotive bearings that a mechanic might have would work or not. I'm
> talking about a thrust bearing that in all is maybe 6 inches wide.
>
> Drax
> KB3X
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|