| To: | towertalk@contesting.com |
|---|---|
| Subject: | [TowerTalk] G-800DXA Rotors |
| From: | kn4n@comcast.net |
| Date: | Thu, 30 Oct 2008 13:04:12 +0000 (UTC) |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
Anyone have problems calibrating this rotator? On page 7 of inst where it shows the metal pin connections, looks like the wiring for control cable from box to round metal pins are numbered looking at the connector from rear? I am going to try take the rotor off tower today and double check this and align it again. _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] New Cables for a Crank Up and NicoPress Clamps, Bob Maser |
|---|---|
| Next by Date: | Re: [TowerTalk] Lossy Traps (really long), Rex Lint |
| Previous by Thread: | Re: [TowerTalk] Lossy Traps (long), barockteer |
| Next by Thread: | Re: [TowerTalk] GiNPOLE PULLEY, K7LXC |
| Indexes: | [Date] [Thread] [Top] [All Lists] |